Barnett clutch

[Sparks]

Anyone running a Barnett clutch out there?  If so did you replace just the just the clutch plate/spring or the plate/spring and disk pack too?  Is the clutch lever force the same as the stock clutch.  Has some slipping in 4th and 5th gear and replaced the stock spring with a Speedstar performance clutch spring and now the clutch lever feels too heavy!

[JIMBO]

Sparks; I had Tousley replace my stock clutch last year with a Barnett (complete) noticed only a silt difference in the clutch lever force, but now it feels normal, The raider is a hydraulic clutch though, I know when I had my 2001 Roadstar after putting a Barnett in it (also complete) the clutch lever force felt a little heavy at first, but never had any slipping problems with a Barnett.

[Sparks]

Jimbo; got the new Barnett clutch in and went for a ride!  Clutch lever force about the same but much smoother clutch engagement than the stock clutch!!  So far I highly recommend Barnett clutches and it was an easy install!  Worst part of the job was getting the old gasket material removed!

[Munchkin & Slim]

I need help.    I purchased the lowering bolt for the back of my bike.  We had some hard luck with % of pay being taken away from Slim and I lost 4 hours a week.
Tousley wants to charge me $125.00 to put this little part in, we just can't swing it.  I have a 2008 Yamaha v-star 650.
If anyone knows how or wants to put it in for me that would be greatly appreciated.

Thanks
Munchkin

[Bob]

didn't you get instructions with the bolt ?

[JIMBO]

Munchkin, bring it over to my place and we will have a look, and see  if I can install it at NO charge 

[Munchkin & Slim]

Thank You will do I will get a hold of you.

[Munchkin & Slim]

Steve will call you and bring it over during the week, maybe the two of you can put your heads together and do it.

[JIMBO]

Sounds good Munchkin.